Activa 12200R Cabrio, Инструкция по сборке и эксплуатации

Страница: 17 / 22

Art. Nr.: 12200R Cabrio
Page 17 of 22
EN
12. Storage of the gas cylinder
The storage of gas cylinders is not permitted in rooms below ground level, in stairwells,
corridors, passageways and driveways of buildings or in their immediate vicinity.
The valves must be fitted with valve protection caps and lock nuts.
Gas cylinders - even empty ones - must be stored upright. Before using the appliance,
especially after a long period of non-use, check the gas-carrying parts for blockages
caused by insects or similar.
Blocked gas pipes can cause a dangerous flashback.
13. Installation
Do not put your barbecue trolley into operation until you have checked that all gas con-
nections are tight. When starting up, keep a safe distance from the burner, as a pilot
flame could occur during start-up. A safe ignition process is guaranteed if you proceed as
follows:
1. Check gas tightness of all lines and valves.
2. Open the cylinder valve.
3. Open all hoods and lids to prevent gas mixture from forming.
➔
Danger of explosion !
4. Turn all the control knobs clockwise (to the right) to the Off position.
5. Press any control knob and turn it anticlockwise to the large flame MAX position. The
mechanical piezo ignition switches on during this process. You will hear a sound from
the control knob. With this sound, the burner should be lit. If not, try several times. If
the burner is lit, press and hold the button for about 5 seconds.
6. If, in exceptional cases, the ignition does not take place after pressing the piezo ig-
niter 3-4 times, repeat the procedure after waiting for approx. 2 minutes.
7. Light the second burner in the same way as described.
8. Always turn the regulation knob slowly to the larger flame MAX position. If you turn it
quickly, the flame may go out.
9. To switch off the burner, press and turn all the control knobs to the OFF/AUS position
and close the valve on the gas cylinder.
Flame appearance:
•
The flame of the burner(s) must be blue and uniform. There must be no yellow
sparks, loud noises or gaps between the bottom of the flame and the nozzle.
•
A yellow flame indicates insufficient oxygen supply. Loud noises or gaps
between the flame and the nozzle are signs of excessive oxygen supply.
•
Check the appearance of the flame every time you use it. If the flame looks abnormal,
contact a specialist to have the appliance reset.