54
l
P2P Wireless Network Name (SSID)
and
P2P Wireless Network Password
:
Reserved.
l
P2P IP Address
: It is the IP address of the receiver in a peer to peer connection. This
IP address is displayed in the lower part of the
Ready to connect
screen. It is used to
access the local management server when AGO is enabled.
Note
: The P2P IP Address must not in the range defined by
P2P DHCP IP Start
and
P2P DHCP IP End
.
l
P2P Subnet Mask
: It is the subnet mask for the network established in the peer to peer
connection.
l
P2P DHCP IP Start
and
P2P DHCP IP End
: These two items define the range of IP
addresses assigned to the connected devices.
3. Click the
Apply
button, and then click
OK
on the pop-up message box to confirm.
4. The receiver reboots, and new settings take effect after the reboot.
5.3.26.
Setting up Wireless Network Parameters
When AGO is disabled, you can define wireless network parameters for accessing the
receiver
’
s local management web server, including wireless network name (SSID) and
password, IP address, subnet mask, and DHCP IP address range.
Follow the procedure below to set up the receiver
’
s wireless network parameters:
1. Go to the
Network Settings
tab page by clicking the
Network Settings
tab.
