ActionTec 56K Internal PC Modem, Руководство пользователя

Страница: 28 / 57

28
Configuring OS/2 WARP
Note: If your computer system uses a Phoenix BIOS, you must disable PnP OS
support for the modem to be recognized in OS/2. See your computer users
manual for information on accessing and changing your system BIOS set-
tings.
Step 1 After you have installed the modem card, turn on your computer. While
OS/2 boots, watch for the OS/2 logo in the upper left corner of the screen.
When you see this logo, press ALT+F1 to get the Startup Menu. Press F5 at
the menu to perform Full Hardware Detection.
Step 2 After OS/2 boots, insert the modem’s installation CD-ROM into the
computer’s CD-ROM drive.
Step 3 Click the PCDOS button on the OS/2 screen. At the command prompt
type:
A:PMDMCFG
and press ENTER. A message similar to the one shown below will be dis-
played. (Actual values will change from system to system.)
Found V.90 PCI Data/Fax Modem
-----------------------------
I/O Port: FC00
IRQ#: 11
Record these values. They will be needed in Step 7 when you modify your
config.sys file and latter when you configure your applications.
Step 4 Be sure the modem’s installation CD-ROM is still in the CD-ROM drive.
Now type the following, as one continuous command (in place of the low-
ercase x, type the drive letter of your CD-ROM drive):
COPY x:\OS2\COM.SYS C:\OS2\BOOT\COM.SYS
and press ENTER.
Note: This will replace your resident COM.SYS file with a new version. OS/2
will not prompt you to overwrite the existing file. Check that the path state-
ments are correct before you press ENTER.