Revised
September 27, 2016
Page | 5
Operating Your Action Trackchair
When you are ready to drive the Trackchair, make sure controls are in the off position
before sitting in Trackchair.
When operating your Trackchair, make sure you are securely fastened in with the 4 point
upper torso support harness.
If you wish to
lock the control
, it is done in this way. After the control has been turned off,
hold the on/off button until the control has cycled both on and then off. Control is now set
in the locked mode.
If you wish to use your Trackchair that is in locked mode,
it can be unlocked in this way
.
Turn control on, hold joystick forward until you hear a beep or three seconds, then joystick
back until you hear a beep or three seconds. It is now unlocked and ready for operation.
The Action Trackchair control has five speeds, one-five and can be changed with the up and
down arrows.
Battery indicator is on the main screen on controls. Battery charge will last up to six hours,
depending on battery condition and type of use the Trackchair is subject to. The Action
Trackchair has a built-in battery charger that plugs into 240 volt outlet using the power cord
provided.
Forward facing lighting is controlled on the joystick control panel by momentarily
depressing the button with the light symbol on it.
If for some reason it is necessary to pull the Trackchair,
disengage the brakes
on the motors
with the levers on back of motors. Push levers to the outsides on both motors.
Do not pull Trackchair at speeds more than 8 km/h.
Action Manufacturing does not recommend operating your Trackchair in salt water.
Although our Trackchairs are powder coated to the highest quality with very durable
powder coat, salt water is very corrosive and causes problems with powder coat and metal.
If your Trackchair has been exposed to salt water, thoroughly wash the Trackchair
completely with fresh water and dry off.
