Revised
April 15, 2016
Page | 13
HANDCONTROL LCD DISPLAY
FAULT/WARNING
REMEDY
Power Section Fault, or Current Sensor
Fault, or EEPROM Fault, or Main Relay
Fault, or Precharge Fault, or HW Failsafe
Fault.
1. Cycle power
2. Replace powerbase.
Handcontrol Fault, or Joystick Fault:
1. Return joystick to neutral and cycle power
Joystick out of center,
2. Recalibrate joystick.
Joystick stuck OOC,
3. Check joystick cable and cable connections.
Joystick Out-of-Range
4. Repalce joystick.
5. Replace hand control.
1. Check cable and cable connections.
2. Replace cable.
1. Check wiring.
2. Replace motor.
3. Replace powerbase.
1. Select drive or a different actuator;
fault may clear.
2. Check wiring.
3. Check that the seatback is not jammed.
4. Check actuator; replace if faulty.
5. Replace powerbase.
1. Select drive or a different actuator;
fault may clear.
2. Check wiring.
3.Check that the seat is not jammed.
4. Check actuator; replace if faulty.
5. Replace powerbase.
1. Select drive or a different actuator;
fault may clear
2. Check wiring.
3. Check that the leg rest is not jammed
4. Check actuator; replace if faulty.
5. Replace powerbase.
1. Recharge battery.
2. Replace old battery.
3. If this is happening frequently,
replace charger.
4. Check charger port on hand control; replace
if damaged.
1. Wait for voltage to come down
2. Replace old battery.
3. Check charger; replace if faulty
Under voltage warning
Overvoltage Warning.
Communications Fault
Brake Fault.
Seatback Actuator Driver Fault
Seat Actuator Driver Fault.
Leg Actuator Driver Fault
