Action JE2000, Техническая информация

Страница: 11 / 25

Construct the final 2 balustrades panels using the dimensions in the picture on the previous page
(top). Fix the largest upper balustrade panel, S1 first using the 60mm screws as before. Make sure
you drill the pilot holes offset so as to avoid splitting the rails. This panel will fit on the outside of the
frame to uprights B, A, A and B. The balustrades must be parallel to the uprights and both will need
to be vertically checked with the spirit level before fixings. The measurement between uprights B
will also need to be checked. The uprights should be parallel top to bottom. Then fix the smaller
panel, S2 to uprights B & C again using the 60mm screws. this should also be fitted to the outside of
the frame. The ladder rails, part P now need fixing using 60mm screws, 4 per rail. Use the drawing
bottom right for dimensions. The top rail will not be fitted as this will restrict access when the ladder
is fitted.