Action JE2000, Техническая информация

Страница: 8 / 25

Pre-build the balustrades on the ground as squarely as possible rather than trying to build them on
the tower frames. To check the squareness measure the diagonal distance from top left to bottom
right. If not just swivel the frame until they are equal. You may find it easier to attach the outside left
and right rails first using the plan measurements. Cut 2 wooden blocks 37mm wide (40mm wide for
the upper rails) and use these as spacers for top and bottom. Pre drill all part C's. The top hole
should be 52mm in and the bottom hole 32mm in. Use the drill bit provided.
You should have all the lower balustrade panels made up at this point. The balustrades must be
parallel to the uprights and both will need to be vertically checked with the spirit level before fixing.
Starting with the longest panel S1 drill holes offset, as in picture below. Fix balustrade rails A on the
outside, to uprights B, C and E using the 60mm screws.
The panel opposite this should be fitted next (S2). It again fits to the outside of the tower. Drill the
offset holes and then fix to uprights D and G using the 60mm screws.
Next fit the panel to the rear of the frame (S2), from the inside, to uprights F & G. Use the 60mm
screws. Remember to check if the uprights are vertical.