ACTinBlack MUM-14, Руководство оператора

Страница: 21 / 59

22
2-1
CHAPTER 2:
PREPARATION FOR USE
2.1 Introduction:
This section contains instructions for installing and attaching
various components and accessories to the MUM-14 for
operation under normal conditions.
2.2 battery Precautions:
WARNING
INSPECT BATTERIES FOR BULGING
PRIOR TO USE. IF THE BATTERY SHOWS
SIGNS OF BULGING, DO NOT USE.
WARNING
DO NOT HEAT, PUNCTURE, DISASSEMBLE,
SHORT CIRCUIT, INCINERATE, ATTEMPT
TO RECHARGE OR OTHERWISE TAMPER
WITH THE BATTERIES. TURN OFF THE
MUM-14 IF THE BATTERY COMPARTMENT
BECOMES UNDULY HOT. IF POSSIBLE,
WAIT UNTIL THE BATTERIES HAVE
COOLED BEFORE REMOVING THEM.
WARNING
DO NOT REPLACE BATTERIES IN A
POTENTIALLY EXPLOSIVE ATMOSPHERE.
CONTACT SPARKING MAY OCCUR WHILE
INSTALLING OR REMOVING BATTERIES AND
CAUSE AN EXPLOSION. FAILURE TO
FOLLOW THESE INSTRUCTIONS COULD
RESULT IN DEATH, INJURY OR IMPOSITION
OF LONG- TERM HEALTH HAZARDS.
2-2
CAUTION
OBEY THE BATTERY MANUFACTURER’S
DIRECTIONS FOR BATTERY DISPOSAL.
2.3 CR123 battery Installation:
The MUM-14 electronic circuit is powered by either a lithium
CR123 battery or a AA alkaline battery. When using a CR123
battery, install as follows.
1. Remove the battery cap by turning it counter-clockwise.
2. Check to ensure the o-ring is present and in good condition.
If not, replace it.
3. Insert the battery into the battery compartment, negative (-)
ends first, positive ends toward the battery cap.
4. Replace battery cap, turning it clockwise until a stop
occurs.
BATTERY
COMPARTMENT
BATTERY
BATTERY
CAP
Figure 2-1 CR123 Battery Installation