actiLib Library 4U
– User and Service Guide
Page 94 of 103
9.9
Removing and replacing the base chassis
You will need a #3 Phillips screwdriver to remove and replace the base chassis assembly.
Before beginning, be sure the tape drive or drives do not contain a tape cartridge. To remove a
cartridge, see
”Moving tapes in the Library” on page 65.
To remove the components in the base chassis and the base chassis from the rack:
1.
Obtain adequate assistance to lift and stabilize the Library during removal and replacement.
2.
Remove the magazines from the Library.
3.
Turn off power to the Library and disconnect all cables.
4.
From the front of the Library loosen the two screws anchoring the mounting brackets on the
Library to the rack. These are captive screws and cannot be removed.
5.
Remove your Library from the rack.
6.
Remove the replacement Library enclosure from the packing materials.
7.
Place the replacement Library enclosure on a solid surface in preparation for installation in
to the rack.
8.
Remove the mounting brackets and guide pulleys from your Library and install them on the
replacement Library.
9.
Loosen the blue thumbscrews on the power supply, and pull the power supply from your
Library.
10.
Install the power supply in your replacement Library.
11.
Loosen the blue thumbscrews on the tape drive, and pull the tape drive handle while
supporting the bottom of the drive to remove from your Library.
12.
Install your drive in the replacement Library enclosure.
13.
Loosen the blue thumbscrews on the Library controller and remove the controller form the
Library.
14.
Install the Library controller in your replacement Library.
15.
Remove the lock on the rear panel.
16.
Store the lock and label to the top cover (see
17.
Slide the replacement Library enclosure onto the metal rails that are already in position in
the rack.
18.
Tighten the mounting bracket screws to anchor the replacement Library enclosure to the
rack.
19.
Plug in the power cord and host interface cable into the replacement Library enclosure.
20.
Power on the Library.
21.
Run the Library Verify test (refer to
OCP “Service: Library Verify”).
22.
Securely package the Library enclosure that was replaced, and return to repair center (see
section 11)
Содержание actiLib Autoloader 4U
