TCM-7411 Hardware User’s Manual
How to Do the Waterproof Installation
The following installation procedure makes the camera be water-resistant even for the situations
where the camera can easily be flooded by pouring rain.
The important part to focus on during the installation:
The protection of the cabling has to be done by a proper flex
conduit. The size of the flex conduit that matches with the
conduit gland is is
3/4”
(trade size), or with actual physical
diameter of
26.441mm
.
Have the Ethernet cable inserted through the flex
conduit together with RJ-45 connector. You may also
consider to do the RJ-45 connector crimping after
pushing the cable through the conduit.
Disassemble the conduit gland.
Slide the
clamping nut
around flex conduit some 10-20
cm
away from the top. Fit the
sealing insert
(made of
rubber) to the top of the flex conduit.
On the camera side, decide which of the 2 possible holes you are going to use to connect the flex
conduit. There is one hole on the side, and one on the bottom. Whichever you pick, remember to
seal off the other one with the metal
patch
(included in the camera set).
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
