ACT ACTENTRY V-IP, Инструкция по эксплуатации и установке

Страница: 24 / 30

ACTentry V-IP Operating and Installation Manual
Page 23
If the V-IP unit does not have a known IP address, then it can be set to a
default value by doing the following:
1. Power up the unit
2. Remove Link J9 (near the CALL connection on the board)
3. LED DS1 (first LED on daughter card) flashes
4. Hold down the tamper switch for 3 seconds
5. LED DS1 stays on
6. Replace Link J9
7. LED DS3 (third LED) flashes
8. Power down the unit.
9. Power up the unit.
10. IP address now set to 192.168.1.66
11. To change the IP address follow the procedure above.
If you want to set the V-IP unit back to DHCP mode, then:
1. Type cmd
2. telnet IP ADDRESS
3. Password: ACT
4. Enter setip 0
5. V-IP is now set for DHCP mode
6. Type quit
Alternatively:
1. Power up the unit
2. Remove Link J9 (near the CALL connection on the board)
3. Power down the unit
4. Replace Link J9
5. Power up the unit