Acson international ACC 10CW, Руководство пользователя

Страница: 24 / 172

Start-Up
The following procedure must be completed before any attempts is made to put the entire system Into opera-
tion:
1) Piping connections completed.
2) Electrical connections completed.
3) Duct connections completed.
4) Auxiliary drain pans in position where required.
5) Drain line draining into drain pans.
6) Filters correctly installed and free of construction debris.
7) Motor-blower assembly rotates freely.
8) Unit Hydro-statically tested and air vented.
Starting The Fan Coil Unit
1) Turn on the switch of water pump.
2) Start water chiller.
3) Operate the fan coil unit by turning on the fan and set the control switch to get the desired speed.
4) Inspect the duct and piping condition and rectify problem (e.g. vibration, noise, etc.) if exist.
Servicing And Maintenance
Fan coil units are designed to operate continuously with minor routine maintenance. Since fan coil units cool
the discharging forced air, the efficiency with which the units operate is directly related to the amount of air
passing through the coil.
Air Filters
The function of the air filters is to remove foreign matter such as dirt, soot, pollen and certain other impurities
from the air passing through it. A clogged or dirty filter not only fails to do the job for which it is designed, but
restricts the flow of air over the coil.
The importance of cleaning the filter before it becomes clogged must be greatly stressed. The frequency with
which a filter should be cleaned will depend upon the amount of dust and foreign material that enters a unit, and
this depends upon location and situation.
The washable viledon or saranet filter may be cleaned by tapping the filter on a solid surface to dislodge heavy
particles. Wash under stream of warm water, with detergent if necessary. Dry it thoroughly before replacing.
Fan Motor
The fan motor is pre-lubricated and sealed at the factory. Therefore, no lubricating maintenance is required.
Coils
Clean coil unit by brushing between fins with a nylon brush. Brushing should be followed by cleaning with a
vacuum cleaner. The coil may also be cleaned by using a high pressure air hose and nozzle if a compressed air
source is available. It should be pointed out that if suitable air filter is used and taken care of properly, the coils
need no cleaning.
Drain Pipe
The drain pipe should be checked before operation of unit is begun. If it is clogged, steps should be taken to
clean the debris so that condensate will flow out easily.
Replacement Of Parts
Replacement of parts are available through your local dealers. When ordering parts, you must supply
1) Model name of the unit.
2) Serial number of the unit.
3) Part name and number.
22
General Operation Guide