GSM-3000
ACS-CONTROL-SYSTEM GmbH | Lauterbachstr. 57 | D- 84307 Eggenfelden | www.acs-controlsystem.de |
| 4 |
Installation and removal of the SIM card
Before processing a RDT the device must be supplied with a SIM card that is activated for data transmission.
Without this card a RDT is not possible.
Before using a SIM card, delete all SMS (sent and received) that are stored on it.
Note:
In the case of an unfavorable configuration of the device there can be caused very high telephone
bills. This can be avoided by using a prepaid card.
The using of a so-
called „prepaid SIM card“ is favorable to restrict the costs at an unfavorable device
configuration to the charged amount.
When using a prepaid SIM card a regular check of the balance is suggested. Additionally it is mostly
necessary to reactivate the balance of a prepaid SIM card regularly (e.g. 1x per year).
For the different defaults and possibilities of charging / reactivation contact the respective telephone
provider.
In the case of an unloaded resp. inactive prepaid SIM card a RDT is only limited possible. The measuring data
retrieval is possible, if it is controlled by the PC, because the call is not carried out by the RDT module.
An alarming function resp. also a measuring value request from a mobile phone per SMS is no more possible,
because the call resp. the recall must be carried out by the RDT module. This is not possible with an
unloaded prepaid SIM card.
For using of SIM card the input of the correct PIN code by using the operation software is necessary. Without
these PIN code a RDT is not possible.
To use the SIM card without the PIN code, this function must be deactivated. This can only be made by a
mobile phone or the like, that configures the SIM card code-free.
For the installation of the SIM card proceed like follows
Screw completely off the cover of the battery receptacle at the
bottom side of the filler cap counterclockwise
(image 1).
Remove the battery by pulling out
(image 2)
.
Below it the SIM card holder can be seen.
Release the fixing of the SIM card holder by sliding it approx.
3mm to bottom
(image 3)
. Open up the slider to bottom in
direction to you.
Insert the SIM card into the SIM card holder. The tapered
corner is positioned at the left side to you.
(image 4)
.
Snap shut the SIM card holder completely and slide it now
upwards approx. 3mm, direction LCD display.
The SIM card holder will snap in at that position
(image 5)
.
Put the battery with the positive pole right into the battery
receptacle (
image 6
). The battery connection is reverse
polarity protected.
Screw-in in the cover of the battery receptacle clockwise till to
the stop (
image 7
).
When opening the cover of the battery receptacle the wasting
of the internal area of the device with humidity or dirt.
This can lead to abnormal behavior, reduced run time or
destruction of the device.
image 1
image 3
image 2
image 4
image 5
image 7
image 6
+pole
