ACS A1270 EMAT, Руководство по эксплуатации

Страница: 17 / 60

А1270 Electro-Magnetic Ultrasonic Thickness Gauge
Operation Manual
17
ACOUSTIC
CONTROL
SYSTEMS
Figure 14 Figure 15
If another transducer is connected, please adjust the instrument for operation using the new transducer.
Press the key manually to switch Off the instrument. The instrument will also be automatically switched off, if no key is
pressed for 10 minutes or no other measurements are performed.
All settings of the thickness gauge will be recorded upon switching off and if the accumulator goes dead.
2.2.3 Configuring and adjusting the instrument to the used EMAT parameters
ATTENTION: PRIOR TO STARTING THE OPERATION AND IF THE TRANSDUCER IS CHANGED,
CONFIGURE AND ADJUST THE INSTRUMENT TO THE INDI-
VIDUAL PARAMETERS OF THE USED EMAT!
Otherwise the instrument will not operate. Any attempt
to switch to one of the measurement modes will display
the "Run probe test" warning message (Figure 14) on the
screen.
2.2.3.1 Selecting the transducer
Do the following to select the transducer:
- press the
key to enter the SETUP mode.
- using the keys go to the Probe option
and press the F3 key (Open) or to enter the library of
the transducers (probe) (Figure 15).
- Using the keys go to the line with the
name of the connected probe (transducer) and press the key
to select it (Figure 16).
After the transducer is selected the adjustment of the
probe testing process to its individual parameters will be
automatically started.
2