acropaq AL49, Руководство пользователя

Страница: 20 / 28

Problem solving
L'appareil de plastification est équipéie de la fonction „ABS Jam Release“
permettant d'éliminer rapidement les bourrages de feuille.
1. In the foil is blocked, switch the appliance off and press the « ABS »
lever on the back of the machine at the top right-hand side to the left.
2. Hold the laminator firmly and pull the foil together with the document to
be laminated out of the laminator's insertion slot.
3. It will probably be necessary to then clean the unit several times as
described in the Section "Cleaning and Servicing".
4. If foil jams occur repeatedly or jammed foil cannot be removed from the
laminator, it means that another foil is blocked in the machine.
In this case a repair might be impossible.
TIPS:
1. Ensure that the pouch has been inserted correctly in the unit.
2. A laminating pouch should also always be filled in as completely
as possible. The pouches half full can cause problems
Laminate the same foil again to improve the lamination result .
If thicker foil is used (100mic, 125mic), please allow the device to heat up longer.
Cleaning and Servicing
Deposits and residual adhesive on the transport rollers can influence the
results of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use: To do this, insert a folded piece of paper in the
insertion slot. Residual adhesive is removed and taken up by the paper
when ejected. Repeat the process several times. Disconnect the power plug
before starting to clean the unit with a damp cloth. If necessary, the housing
can be cleaned using a cloth moistened with clean water with a little mild
soap applied. Never use any solvents or aggressive cleaning agents.