Acromet ACRO-SMART AS.1, Руководство пользователя

Страница: 14 / 45

Acro-Smart Electronic Series January 2017
Acro-Smart Electronic Series
Pa
ge
10
CAUTION
6.9
When power is turned off, or a power failure has occurred, the Blue LED lights
on the key pad, will flash ON and OFF, when the power is restored.
To restart the pump press the green start button to restore the preset
default (L/Hr) setting and then adjust the manual capacity button to your
specific requirements.
6.10
To reset the default (L/Hr) setting.
6.10.1 Stop the motor
and the Blue LED lights will flash ON and OFF.
6.10.2 With the LED lights flashing press the up arrow until the LED’s reads
“P051”.
6.10.3 Press ok .
6.10.4 Press the up or down arrows to the desired default flow rate.
6.10.5 Press ok to enter the new setting.
6.10.6 Press the start button .
Note:
1/ Do not set the “Default” P051 to zero (0).
2/ The blue LED readout is only associated with the manual adjustment and it
does not change when the pump is operated from a 4-20mA input signal.
The Manual Capacity Adjustment Panel
is normally located on the
side of the motor.
This unit can also be mounted remotely. For remote mounting the cable length must
not exceed 15 metres.
Note:
1/ The programming parameters for your pump have been pre-set and do not need
any adjustment.
2/ Wiring of the pump is as per the wiring drawings section 12 of this manual.