©2017 ACP, Inc.
Cedar Rapids, IA 52404
Page 14 of 16
Part No. 20000609
Revised 06/29/2017
To program the oven using USB Flash Drive:
Oven must be in Standby mode (Preheat must be OFF)
Note:
A standard USB flash drive is compatible with oven.
1. Remove protective cover from bottom of vertical keypad.
2. Insert the USB Flash Drive into the slot located below the vertical keypad.
3. Open the oven door.
4. Press and hold the
5 pad
until USB appears in the display.
5. To transfer programming
FROM
the USB flash drive to the oven, press the
1 pad
. “USB TO OVEN”
will appear in display.
OR
To transfer programming
TO
the USB flash drive from the oven, press the
2 pad
. “OVEN TO USB” will
appear in display.
6. Press
START pad
, on vertical keypad to begin transfer.
7. Oven displays “LOADING” in the display for approximately 10 seconds.
8. When the transfer is complete the display will beep and display “DONE” and number of programs
saved.
9. Press any pad to clear the display or shut the door and the display will read “READY”.
Error Codes
:
1.
NO USB:
Remove flash drive from USB and reinsert flash drive into USB and retry.
2.
RESET OVEN:
Unplug oven from outlet and plug in oven and retry transfer.
USB Flash Drive Operating Instructions
USB Port
PROGRAM SAVE
TURN PREHEAT OFF