9
section of these instructions, or online at
www.argos-support.co.uk
If you still require further assistance, call one of our experts on
0345 600 3021
8
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Adjusting the volume
On the Tower speaker:
Turn the volume control clockwise to increase the volume and anti clockwise to decrease the
volume. The volume control ranges from 0 (no sound) to 30 (maximum volume)
Using the remote control:
Press and release the ‘Vol.+’ or ‘Vol.-’ buttons to increase or decrease the volume in steps.
Press and hold the ‘Volume-’ or ‘’ buttons to progressively increase or decrease the
volume.
Mute
Press and release the ‘Mute’ button on the remote control to turn the sound off. ‘MUTE’ will be
displayed
Press and release the ‘Mute’ button to turn the sound on again.
Adjusting the treble setting
Use the ‘’ or ‘Treble -’ buttons on the remote control to adjust the treble setting. When
you adjust the treble, please check the display, which will confirm the setting. The treble
control ranges from -4 to +4.
Adjusting the bass setting
Use the ‘Bass +’ or ‘Bass -’ buttons on the remote control to adjust the bass setting. When
you adjust the bass, please check the display, which will confirm the setting. The bass control
ranges from -4 to +4.
Switch on
Press and release the silver control ring on the left hand side (Mode), or the red button on
the remote control to power on the product.
The first time that you use your product it will power on in Bluetooth mode. ‘HI’, followed by
‘BT’ will be displayed.
The white LED ring will flash as the product searches for Bluetooth devices.
Note: After first use, your product will always power on in the mode it was last used in (BT, FM
Radio, AUX or Line in).
Switch off
Press and hold the silver control ring on the left hand side (Mode) for 3 seconds and then
release, or press and release the red button on the remote control to power off the
product.
The Tower speaker will go into Standby mode, the white LED ring on the front of the Tower
speaker will remain on but the display will switch off.
Note: If you do not use your Tower speaker for 10 minutes and no audio signal is received, the
product will automatically go into standby mode.
To completely switch off the Tower speaker, switch the power switch on the back of your
Tower speaker to ‘Off’ and switch off the mains power at the wall socket.
Change the mode
On the Tower speaker:
Briefly press and release the silver control ring on the left hand side (Mode) to switch between
Bluetooth (BT), FM Radio (FM), Auxillary (AUX), and Line in (LINE IN) modes.
Using the remote control:
Press and release the ‘Input’ button to switch between Bluetooth (BT), FM Radio (FM), Auxillary
(AUX), and Line in (LINE IN) modes.
Note: To use either AUX or LINE IN modes you need to connect your Tower speaker to your
audio output device using a suitable 3.5mm audio lead or television using a suitable twin
RCA lead.
Using your Acoustic Solutions Tower speaker
