12.
13.
14.
Refer
to
"Recommended Set-Up and Speaker Placement" for
room placement suggestions. When
you
have determined where the speaker will beplaced. plug the interface unit into a live wall outlet.
The system should remain plugged in
at
ALL
times for proper performance.
NOTE
The current draw
of the MK-121 Interface unitis very low: about five watts
Set the High Frequency balance pot on the interface at approximately the one o'clock position for
your initial listening tests. Thiscontrol effectsthefrequencies primarily in the last octave(10-20KHz) of
the musical spectrum. The
proper setting
Will
be that which yields the correct degree
of "sparkle" or
"airiness" of the sound.
Repeat the above procedure for the other speaker.
ASSEMBLY
INSTRUCTIONS
For Models Two/MH
&
Three/MH
PLEASE
READ COMPLETELY
BEFORE YOU
BEGIN
TO ASSEMBLE YOUR SPEAKER SYSTEM!
1.
To assemble the speaker system, you will
need t
o be allowed enough floor space for the bottom of speaker
panel to be parallel to, and five feet from therearwall. In a later step you will be required to lean the
system against this rear
wall.
Remove one speaker panel unlt from box. Remove plastic bag (HINT
spread bag
on
floor
before
Iaying down speaker to protect grille cloth.)CAREFULLY
lay speaker down
in position described above.
DO NOT ALLOW
THE
SPEAKER
TO DROP TO
THE
FLOOR!!!
2. Remove one woofer assembly from its
box.
Be
careful not to put pressure on binding posts, high
frequency control knob or woofer. Set hardware kit aside.
Set woofer assemblys front/bottom edge
on the lower rear edge of the speaker's frame, lt will balance. Using a flat blade screwdriver or 5/16"
net driver, remove the plastic Insulator cover from the front (unfinished side)
of the woofer box as
follows 1) Loosen top
two
screws three turns
2)
Remove lower
two
screws:
3)
Slide plate down and
off
of woofer
box.
I
3 .
Note the three wire groups originating from the
speaker
system. Visually identify them
as:
the
RCD
GROUP, with
a pin plug on the end: the
BLUE
GROUP, with a BLUE-sleeved hook
on
the end Insert the
RED GROUPs pin plug into the RED jack on theconnector plate. entering from the LOWER sidcotthe
jack. Place the BLUE hook UNDER the lower thumbscrew securely. (NOTE Warning label identifies
which thumbscrew
is
for the
WHITE
GROUPS hook to other(UPPER) thumbscrew in a similar fashion
as
the blue group. The three wire groups should then be positioned
to
exit at the bottom/center
Of
connector plate.
4. Reinstall the platic insulator plate as follows:
1)
Slide the plate under the two upper screws that had
been loosened in STEP 2.2) Position the three wire groups such that they fit under the U shaped flap at
the lower/center of the insulator plate.
3) Install the two lower screws and tighten securely, being sure
.3