CLEANING
Speaker cloth may be cleaned with
any commercial cleaning fluid,
or anycleaner designed to be used
with polyester knit fabrics. Use a cleaner such as
K2R
for small concentrated spots.
REMOVAL
OF
INTERFACE FOR MODELS TWO/M
&
THREE/M
WARNING
ALWAYS UNPLUG
THE
LINE CORD BEFORE REMOVNG
THE
INTERFACE!
If the interface must be removed from the speaker, the following procedure
i s
necessary to discharge the
panels
1,
UNPLUG the interface from the AC outlet and dlsconnect the speaker leads from the amplifier.
2. CAREFULLY, lay the speaker on the floor. DROPPING IT CAN
RESULT IN
DAMAGE!
3. Unbolt the interface.
4.
Set the interface on the floor behind the speaker, k i n g careful not
to
unplug the three wire groups
from the speaker
5.
Remove the center
RED
pin plug. Hold the wlre an Inch behind the pin and GENTLY pull.
DO NOT
GRAB
THE
PLUG! Touch the RED tlp to either the
BLUE or the WHITE terminal on the circuit board
6.
Loosen the
two
thumbscrews and remove the hooks
WARNING: High static voltages are present in the charged panel. Failure to follow these procedures
will
result in an annoying, but harmless electrical shock.
REMOVAL
OF HYBRID
MODULE FOR MODELS TWO/MH
&
THREE/MH
WARNING
ALWAYS UNPLUG THE LNE CORD
BEFORE
REMOVlNG
THE
HYBRID MODULE!
If the Hybrid Module must
be
removed from the speaker, the following procedure is necessary to
discharge the panels
1, UNPLUG the Hybrid Module from the AC outlet and disconnectthe speaker leads from the amplifier.
2.
CARERILLY, lay the speaker on the floor DROPPING CAN
RESULT IN DAMAGE!
3.
Unbolt the Hybrid Module, both thetwoscrewson the top of the module, and the threescrewsonthe
4. Set the module on the floor behind the speaker, being careful not to unplug the three wire groups
5.
Remove the plastic insulator cover from the Hybrid Module.
6.
Remove the center
RED
pin plug. Hold the wire an inch behind the pln and GENTLY pull.
DO
NOT
GRAB THE PLUG! Touch the
RED t i pto either the
BLUE or the WHITE terminal on the circuit
board
7.
Loosen the
two
thumbscrews and remove the hooks.
8.
Replace the plastic insulator cover
WARNING High static voltages are present in a charged panel. Failure to follow these procedures will
result in
an
annoylng. but harmless shock.
bottom of the speaker frame.
from the speaker.
LIMITED WARRANTY
Amustat Corporation warrants to the owner that the Amustat loudspeaker system excluding the
Dynamic Woofer. will perform as specified and
that it will befreeofdefectsin materialsand workmanship
for a period
of
FIVE
YEARS
from the date
of
origlnal manufacture.
8