INSTALLATION, OPERATION
& MAINTENANCE MANUAL
NEO-METRO FIELD SERVICE
TOLL FREE
LOCAL
FAX
800-743-8259 •
626-855-4866 •
626-855-4863
Date: 01/31/22
Part #: 0696-001-001
Page
of 4
3
11114
6. Test connection before covering or
concealing. To test: Plug Drain and fill
Receptor with water. Check for leaks.
This
must be done before finishing walls.
5B. Use Screwdriver if necessary.
7. Attach Drain Grate and Strainer to Drain
Assembly.
1. Remove Drain Grate and assemble Drain
Body to Corterra
and tighten Locking
Nut to affix Drain to
.
Base
Base
2. Cut & dry-fit Waste Pipe to 1/2” below
bottom of shower base.
3. Position Corterra
over 2” IPS Waste
Pipe assembly and ensure the Pipe is
centered in the Drain Body. Use a
Carpenter’s Level to ensure base is level.
Base should be evenly supported.
Base
4. Lubricate Gasket with soap solution and
stretch over 2” Pipe with beveled edge and
push Gasket as far as possible into joint.
DRAIN AND WASTE INSTALLATION:
5A. Thread Caulking Nut with Wrench provided
to secure Drain to Pipe.
1
2
3
4
5A
5B
LOCKING NUT
FIBER WASHER
RUBBER WASHER
DRAIN BODY
DRAIN GRATE
GRID STRAINER
CAULKING NUT WRENCH
RUBBER CAULKING
GASKET
DRAIN ASSEMBLY
CAULKING NUT
WRENCH
CAULKING NUT
CAULKING GASKET
CAULKING NUT
WRENCH
DRAIN ASSEMBLY
CORTERRA BASE
CAULKING NUT
1
2
"
CORTERRA
BASE
FINISHED SUB
FLOOR
MORTAR OR
THINSET
5"
WASTE PIPE
