www.aconno.com
August 5, 2016
The information contained in this document is the property of aconno GmbH and should not be disclosed to any third party without written permission.
Specification are subject to change without notice. V.1.1 © aconno GmbH 2016
14
4. Connection pinout – peripherals and jumper
description
The following chapter describes the jumper header and expansion header pinouts and
their functions.
4.1. Jumper Blocks
The ACD52832 is equipped with various jumper blocks to give the developer total
control of the board features. In order to use the on-board devices and expansion pin
headers correctly, we recommend that the developer acquires a good understanding of
jumper blocks first.
Jumper block P6
The P6 jumper block gives you the choice to either use an on-board component (i.e. the
readout of the light sensor) or an expansion header pin on a certain controller pin.
The
jumper in the position left connects the corresponding on-board device, in the position
right it routes the controller pin to the expansion header J4.
Picture 3: Position on the board
Picture 4: Jumper block P6