Acon On Call, Руководство пользователя

Страница: 9 / 25

11 12
En En
Battery may not be preinstalled in the meter. Two CR 2032 3.0V coin
cell batteries are required. Please find the batteries in your carrying
case and install them according to the following steps:
1. Turn over the meter to locate the battery
cover. Press the battery cover tab on the top
and lift the cover to open it.
2. Insert two new CR 2032 3.0V coin cell
batteries on top of the plastic tape. Make
sure it is aligned with the plus (+) side facing
up in the battery carrier.
3. Close the battery cover and make sure that it
snaps shut.
Install the Battery
SN 404A0000001
Before testing, the following steps should be followed:
Every time you change to a new box of test strips, you need to insert
the code chip packed with the new box of test strips.
1. Take the code chip from the test strip box. Compare the code
number on the code chip with the code number printed on the test
strip vial label (or on foil pouch). If the two numbers are not identical,
you may get inaccurate results. If the code number on the code chip
does not match the number on the test strip vial (or on foil pouch)
with which it was packaged, please contact your local dealer
immediately.
2. With your meter turned off, insert the new code chip into the code
chip slot of the meter. It should easily snap into place. The code
chip should remain in the meter, do not take it out until you change
to another new box of test strips.
3. Turn the meter on by inserting a test strip. You can see the code
number appear on the center of the screen. If the code number on
the code chip does not
match the number that is
displayed on the screen,
please contact your local
dealer immediately. Note:
If a test strip is inserted and
no strip code is stored in
the memory, the display will
flash "---" and "CODE".
Before using your meter for the first time, you will need to adjust the
settings that are listed in detail below.
1. Meter Setup Mode: Press the S button for 2 seconds to enter the
meter setup mode. The meter will automatically enter the setup
mode when turned on for the first time by any method.
2. Clock: Set the clock for either 12 or 24 hour mode. Press the M
button to switch between the two settings, then press the S button
to save your choice and then start setting the year, month and date.
Note: The clock needs to be reset after replacing the battery.
Step 2 - Adjusting the Meter Settings Step 2 - Adjusting the Meter Settings
Meter Setup Before Testing
Step 1 - Coding the Meter Step 1 - Coding the Meter
SN 404A0000001
mmol/L
mg/dL
CTRL 2
16.4-21.7
295-390
CODE
135
CODE
135
135