Acom 2100 Скачать руководство пользователя страница 5

Страница: 5 / 6

Turn the Mains board back to its original position, pull out the 8 wires carefully,

and tighten the holding screws.

From the voltage selection table shown below, select the row matching your

nominal mains voltage. Connect the 8 labeled HV-transformer primary wires to

the voltage selector terminals accordingly.

Содержание 2100

Страница 3: ... 2 Plug in the filament supply connector ...

Страница 4: ...eaded on each transformer HV lead in the intended chassis wall slots in order to protect both HV leads from sharp metal edges Make sure the grommets fit the slots fully and properly Thread the 8 primary leads of the HV transformer labeled with numbers 1 8 through the opening in the sub chassis carrying the Mains PCB ...

Страница 5: ... pull out the 8 wires carefully and tighten the holding screws From the voltage selection table shown below select the row matching your nominal mains voltage Connect the 8 labeled HV transformer primary wires to the voltage selector terminals accordingly ...

Страница 6: ...ing to the selected table row Connect all five connectors you disconnected in the beginning plus two new connectors from HV transformer Replace the cover reinstall all nine M3x6 screws first loosely and finally tighten them properly C A U T I O N If the amplifier is wired for 100 120VAC do not forget to replace the two rear panel fuses ...