Acom 2100, Руководство по установке, Страница: 2 / 6

Turn the Mains board right.
Take the transformer out of the carton and remove the shipping board. Keep the
board together with the four long screws and all packing for possible future
transportation. For transformer mounting, four shorter screws (metric M6x12)
are provided in a polyethylene envelope inside the same carton.
Move the transformer, using its band handle, into the compartment. Take care
not to damage the wiring or components and position the transformer so that
the captive nuts are aligned with the corresponding chassis holes. Make sure
that the transformer is centered. The transformer screws must be installed NOW
for safe operation.
Put a lock washer and a flat washer on each screw.
Holding its two sides (front and back) simultaneously, pull the amplifier
towards you just far enough that the two outside transformer captive nuts
appear off the table edge. Support the amplifier until your assistant loosely
screws in the two outside transformer-mounting screws. Pull the amplifier a
further 12-13cm (about 5 inches) until the other two captive nuts appear off the
table edge. Keep supporting the amplifier until your assistant loosely screws
them in. After checking that the transformer is centered, tighten all 4 screws.
Now move the amplifier back over the table.