ASSEMBLY AND PROGRAMMING MANUAL FOR THE
AUTONOMOUS INS-ZS CODE LOCK
The autonomous INS–ZS code lock is a microprocessor
device which serves the purpose of controlling one or two
outputs independently, by means of the proper code for
the given output. The outputs may control outdoor devices
e.g. an electric door strike. INS-ZS has maximum 255
opening codes created on the basis of the Table of Codes
compatible with other ACO products.
1. INSTALLATION
The base of the INS-ZS lock is flush-mounted and fixed by means of expansion bolts. The wires are put through hole 1.
The lock is connected according to schedule placed in the further part of the manual. The enclosure is locked using the
Allen key with the size of 3, by means of 4 screws. Holes No. 2 serve the purpose of temporary installation of the lock
by means of e.g. nails, in case of placing the device in soft materials, e.g. polystyrene. Holes No. 3 facilitate the
installation in case of using the assembly foam.
2. METHOD OF OPERATION
Depending on the mode of operation, the activation of one of the two outputs consists in:
-
In the mode of 255 codes – selection of the code ordinal number by means of the keypad, approval of the
selection by push-button (key) and entry of the proper four-digit code from the attached Table of Codes.
