ACO 6236, Инструкция по эксплуатации

Страница: 12 / 154

11
Operating Portion
Light key
The backlight illuminates the display in darkness, which goes out automatically 30 seconds
later or by pushing the key again.
Menu key
It is pushed to set up the measurement condition, when the display is adjusted to 1/3
page of the menu panel.
The item is selected with cursor key
▲▼ , and input starts with , as well as the
alteration with ▲▼ . To go back to the measurement setting screen, push [Set] key
again.
Cal key
When the calibration or level setting with the equipment connected, this key is used.
Set key
The key to be used to fix the input.
Meas. Time key
The key to set the measurement period (interval time terminated with a pair of Star/Stop).
It changes on pushing the key as: key is pushed again.
1s, 3s, 5s, 10s, 1m, 5m, 10m, 15m, 30m, and 1h, 8h, 12h, 24h, and
＊＊＊
(Forever: Until
Stop).
A ・ C ， Z key
The key to select frequency weighting A, C, and Z (FLAT)
F
・
S
，
Imp key
The key to select time-weighting Fast, Slow, and Imp
Range key
Range setting key which enables the following 6 ranges:
20 ～ 80 、 20 ～ 90 、 20 ～ 100 、 20 ～ 110 、 30 ～ 120 、 40 ～ 130
Mode/Leq ・ Lx key
The key to display the calculation results. Each push gives various calculation results
selected on the Menu screen.
Card key
The key to use various option cards
Pause key
By pushing the key, the measurement is paused to eliminate any unexpected noise or
anomaly during the measurement. It is resumed by pushing the key again. By using the
data elimination function, it is possible to exclude the data 3 or 5 seconds before the key is
pushed.
Start/Stop key
The key to start the measurement of various mode or to terminate it.