Acnodes PC 5170, Руководство пользователя

Страница: 46 / 192

PC 5170 Flat Panel PC
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Unpack the PC 5170.
Set the jumper settings.
Install HDD, FDD and CD drive.
Mount the PC 5170 flat panel PC.
Connect peripheral devices to the bottom panel of the PC 5170.
Configure the system.
Step 0:
3.4 Unpacking
To unpack the PC 5170 flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the PC 5170 flat panel PC has
been properly installed. The plastic cover ensures the screen is protected
during the installation process.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Use box cutters, a knife or a sharp pair of scissors to cut the tape that seals the
top side of the external (second) box.
Open the external (second) box.
Use box cutters, a knife or a sharp pair of scissors to cut the tape that seals the
top side of the internal (first) box.
Lift the monitor out of the boxes.
Remove both polystyrene ends, one from each side.
Make sure all the components listed in the packing list are present.
Step 0:
Page 43