XP-1200F
9-
3. If changing the lamp, remove old lamp from lamp socket. Hold the new lamp only by its
ceramic base. Never touch the glass bulb. Insert the new lamp in the lamp socket.
4. With the nipple of the lamp facing the back insert one end of the lamp into the socket.
Pull up the spring of the other side of the socket and snap the other end of the lamp into
place. Make sure it fits correctly into the socket.
Please refer to the diagram to know how
to put the lamp in correct position.
6. How To Set The Unit
6.1 Main Function
To select any of the given functions, press the
MENU
button up to when the required one is
showing on the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been selected,
press the
ENTER
button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press
the
MENU
button. The main functions are showing below:
XP-1200F
10-
Address Setting
MENU
Control Setting
Self-Test
Fixture Hours
Lamp On/Off
Reset
DMX 512 Address Setting
Press the
MENU
button until the
is showing
on the display. Pressing
ENTER
button
and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once
the address has been selected, press the
ENTER
button to setup or automatically return to
the main functions without any change after 8 seconds. To go back to the functions without
any change press the
MENU
button again.
Control Setting
Press the
MENU
button until the
is blinking on the display. Pressing
ENTER
button
and the display will blink. Use
DOWN
and
UP
button to select the
(Enable the black
out while changing colors) or
(Unable the black out while changing colors) mode.
Once the mode has been selected, press the
ENTER
button to setup or automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change press the
MENU
button again.
Self-Test
Press the
MENU
button until the
is blinking
on the display. Pressing
ENTER
button and the unit will run self-test by built in program. To go back to the functions press
the
MENU
button again.
Fixture Hours
Press the
MENU
button until the
is blinking on the display. Pressing
ENTER
button
and the display will show the number of working hours of the unit. To go back to the
functions press the
MENU
button again.