Firmware Version
Select Firmware Version, press the ENTER button to confirm, the software version will show
on the display. Press the MENU button back to exit.
Factory Setting
Select Factory Setting, press the ENTER button to confirm, present mode will blink on the display.
Use the DOWN and UP button to select the No or Yes (Switch back to default settings). Hold and
press the MENU button about one second or wait for one minute to exit the menu mode.
Reset
Select Reset, press the ENTER button and the fixture will now reset.
6. How to Control the Unit
You can operate the unit in two ways:
1. Master/slave built-in preprogram functions
2. Universal DMX controller
6.1 Master/Slave Function
By linking the units in master/slave connection without DMX control, the first unit will control the
other units to give a synchronized light show.
6.2 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512
channels so that the units can receive DMX signal.
Press the MENU button, and the display will blink. Use DOWN and UP button to change the
DMX512 address. Once the address has been selected, press and keep ENTER button pressed up to
when the display stops blinking or storing automatically one minute later. To go back to the
functions without any change press the MENU button again.
If you use please refer to the following diagram to address your DMX512 channel for the first 4
units.
12C
