the display and move all the motors to their ‘home’ position. After that the unit will be ready
to receive DMX signal or run the built in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, synchronized light show. This function is good when you want an instant
show.
5.2 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channels so that the units can receive DMX signal.
Press the
MENU
button up to when the “LP-TS100" showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512
address. Once the address has been selected, press and keep
ENTER
button pressed up to
when the display stops blinking or storing automatically one minute later. To go back to the
functions without any change press the
MENU
button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 units.
2 channels
：
6. DMX512 Configuration
Channel mode
（
2channels
）
9A
