ACME Eventx 100, Руководство пользователя, Страница: 7 / 32

The DMX output and input connectors are pass-through to maintain the DMX circuit, when one of the units’ power
is disconnected.
- Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is
between 0-511 (usually 0 & 1 are equal to 1).
The end of the DMX 512 system should be terminated to reduce signal errors.
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.
3.4 DMX 512 controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512 channel so that the units
can receive DMX signal.
If all units have same DMX address, they will do simultaneously the same task as order the DMX controller.
If you set different address, each unit will start to respond of the DMX controller signal channel, based on the quantity
of control channels of the unit.
Press the
MENU button up to when the DMX Address is showing on the display. Press the ENTER button and the
display will blink. Use the DOWN and UP button to change the DMX512 address. Once the address has been selected,
press and keep the ENTER button pressed up to when the display stops blinking or storing automatically 8 seconds
later. To go back to the functions without any change press the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
5 Channels 1 6 11 16
7 Channels 1 8 15 22
8 Channels 1 9 17 25
3.5 IR remote control
STANDBY: Press the button to blackout the unit. It is invalid to press the other buttons when entry the Standby status;
And it will return to the original state when exit the Standby status.
FULL ON: Press and hold the button can show all the light, and it will return to the original state when release the
button.
ZOOM+/ZOOM-: Press these buttons to zoom in or zoom out.
/DIMMR-: Press these buttons to adjust the output intensity.
COLOR WHEEL +: Press the button to select the mexy color in the pre-programmed sequence. (Totally 33 colors)
COLOR WHEEL -: Press the button to select the previous color in the pre-programmed sequence. (Totally 33 colors)
FAST/MEDIUM/SLOW: Press these buttons to acive and setup the speed of show for color random.
RED/FUSHIA/BLUE/LIGHT BLUE/GREEN: Press these buttons to select the color.
2800K/3200K/4000K/5600K/8000K: Press these buttons to select the color temperature.
6
A