3-
y
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
y
Do not open the unit within five minutes after switching off.
y
The housing, the lenses must be replaced if they are visibly damaged.
Caution
1. There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact your nearest dealer.
2. Possibly hazardous optical radiation emitted from this product.
Installation
The unit should be mounted via its metal hole on the bracket. Always ensure that the unit
is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a 10 times
weight of the unit.
2. Technical Specification
z
1/1MSL/3/4/5/6/12/24/48/50 channels switchable and two extra Rc8ch mode:LC1 and
LC2. For Rc8ch mode,please refer to the user manual of LED-RC8
z
Automatically switching between music trig and auto mode
z
Great built-in programs under Master/Slave mode trigged by music
z
Individual control of each LED cluster
z
Sound sensitivity adjustable via the menu
z
Auto-fading show with 5 different speeds
z
Specially designed stand for floor operation
z
LCD display for easy addressing and setting
z
Power Supply:
120~230V 50/60Hz
z
Fuse:
T 6.3A
z
Power consumption:
74W
z
LED:
3W Tri-color x 16pcs
z
Dimension
:
965 x 167 x 152 mm
z
Weight:
6.4 kgs
16-
4.5 DMX512 Connection
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in
the DMX-output of the last unit.
3. Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to
the input of the next unit. The cable can not branched or split to a `Y` cable. DMX 512 is
a very high-speed signal. Inadequate or damaged cables, soldered joints or corroded
connectors can easily distort the signal and shut down the system.
4. The DMX output and input connectors are pass-through to maintain the DMX circuit,
when power is disconnected to the unit.
5. Each lighting unit needs to have an address set to receive the data sent by the controller.
Содержание CB-16TC
Страница 7: ...13 DMX Configuration 6 ...
