Overview
The FSC-1 is a digital EC motor control. The control has a simple
five
bu
�
on interface with a four digit LED
display. All programmable parameters can be accessed through the user menu with the
five
bu
�
on interface.
There are two ECM connectors with modula
�
ng outputs, one 0-10V output, and one 0-10V DC input. The FSC-
1 is compa
�
ble with Telco Green, Genteq, Nidec, and U.S. Motors. User parameters are stored in non-
vola�
le
memory, and are retained
ev
en during a power outage. The FSC-1 is powered by 24V AC.
Normal Opera
�
on
Pulse Applica
�
on
Eve
ry ten seconds the FSC-1 display will toggle between the current percent of run speed and the current
RPMs. The percent of run speed can be changed by using the
and
keys followed by the
key to
save
your changes. You also h
av
e the
op�
on of using the control locally or remotely through a poten
�
ometer,
2 Speed Switch, or a 0-10V reference where 0V is 0% and 10V is 100%, unless
ov
erridden by the low speed and
high speed limits. You can access programming mode by holding the enter key for three seconds.
0-10 Applica
�
on
In the 0-10V applica
�on
you are pr
ovi
ded a programmable 0-10V reference. The
display shows the selected
vo
ltage. The
vo
ltage is easily changed using the
and
keys followed by the
key to
sav
e your changes.
Programming
Please refer to the “FSC-1 Menu Map” on page 9 for
edi�ng
parameters within program mode. To enter
program mode hold the
key for three seconds
un�l
“APPS” is displayed. Use the
and
keys to
navigate
to the desired menu parameter shown in column 1 of the menu map on page 9. To edit a menu
parameter press the
key once on the desired parameter. The current
va
lue will be displayed in column 2
and
keys to change
val
ues within a parameter. The
of the menu map on page 9. Also use
parameter will blink
un�l
the user presses
to
save
the changes or the
key to cancel without
saving.
If a key is not pressed for
fi�een
seconds, the control will return to normal
opera�ng
mode.
Different
parameters are as follows:
1. “APPS”: Prompts the user to select which applica
�o
n to u
�l
ize.
2. “SP1”: Sets the speed of the motor for Setpoint 1.
3. “SP2”: Sets the speed of the motor for Setpoint 2.
4. “LSPD”: Sets the lowest possible speed the motor will operate at. If the
bu
�
on is pressed one
more
�me
passed the “LSPD” limit, the control will turn
off.
5. “hSPD”: Sets the highest possible speed the motor can operate at.
6. “tyP”: Sets the type of motor the control is
configured
for. The FSC-1 is
compa�ble
with
Genteq, Nidec and US motors.
7. “re”: Allows the user to select local control or remote control type.
8.
“ver”:
Allows the user to
view
the current
so�ware
version
number.
FSC-1 DIGITAL CONTROL SETUP
Control is only used on ECM motors
Page 8
Содержание 924738
Страница 9: ...GENTEQ US Motor Page 9 ...