CENTAURI-200 User Guide
VT-ENG-TMP-UG | Rev 1.1 | 31-Jul-19
Volansys-Confidential
Page 23 of 31
5 E
ND DEVICE SETUP AND CONTROL
5.1 Z-Wave or Zigbee modules
The gateway will have either of one module installed on MikroBus if it is configured for Z-Wave or
Zigbee.
Figure 5- 1 Mikrobus based Z-Wave 700 module
Figure 5- 2 Mikrobus based Zigbee JN5179 module
5.2 Z-Wave/ ZigBee end Device commissioning
1. Open the mobile application and go into the list of registered gateway list.
2. Click on the registered gateway in which the user wants to add the
Z-Wave / ZigBee
end
device.
3. The user can see the registered end device list. If any end device is already registered, they
will be shown, if not, the below screen will be displayed.
4. To commission the end device, select the “End node commissioning” option from menu (top
right side of the screen)
5. Gateway will open end device provisioning window. Now follow instruction given in user
manual of specific end device to pair it with Gateway. (E.g. For bulb, switch on/off to pair.
This will be manufacturer specific)
6. If device is added successfully, user will see it added in the application and shown as green.
