-4-
From each PC, run a command prompt and execute the ping command to
verify the link.
From PC 1 : type
ping 192.168.1.2,
verify the answer returned by PC2
« Answer from 192.168.1.2 … »
From PC 2 : type
ping 192.168.1.1,
verify the answer returned by PC1
« Answer from 192.168.1.1 … »
Notice :
The Diag & Wlan Tx/Rx LED are flashing while the bridge is not connected to
the AP.
WLan Tx/Rx LED is flashing blue for WLAN Tx or Rx activity.
FINAL INSTALLATION
6.
Install the device
Place the device in an appropriate place using the panel mounting kit. The
device can be installed outside.
7.
Modifying device’s parameters
Via the integrated web management interface, set the following main
parameters:
o
The country or region :
this parameter is crucial for proper
operation, for it determines and fixes country dependent legal
limitations
o
The operating mode: AP mode with or without WDS, Infrastructure
bridge mode, ad-hoc bridge mode
o
Wifi security parameters (WEP, WPA, WPA-PSK, WPA2, WPA2-PSK,
MAC address filtering, SSID broadcast or not)
o
Wifi parameters: 802.11 mode, radio channel (take care about
legislation), SSID
