-12-
LEDs definition
9 status LED indicate:
LED
Color
Description
Power 1
Green
This led is ON when a power supply is connected to
pin 3/pin 4 of the power connector.
Power 2
Green
This led is ON when a power supply is connected to
pin 1/pin 2 of the power connector.
Diag
Red
This led indicates the unit operational state.
ON : Failed, OFF : OK. It stays ON for less than 10s
after power is applied then it goes OFF.
WLan
Tx/Rx
Blue
Flashing for WLAN Tx/Rx activity.
LAN 1
10/100
Green
This LED is ON when LAN1 is connected to a 100
BASE T device. It remains OFF when connected to
a 10 BASE T device.
LAN 1
100
Green
ON when the LINK to the remote device on LAN1 is
established, and flashing for Tx/Rx activity.
LAN 2
10
Green
This LED is ON when LAN2 is connected to a 100
BASE T device. It remains OFF when connected to
a 10 BASE T device.
LAN 2
100
Green
ON when the LINK to the remote device on LAN2 is
established, and flashing for Tx/Rx activity.
C-KEY
Red/
Green
Off:
no C-Key is detected.
Red:
the C-Key data is invalid or corrupted.
Green:
the C-Key data is valid.
Blinking:
during reads and writes to the C-Key.
The 10 BASE-T or 100 BASE-Tx Half/Full duplex mode is negotiated
according to 802.3u recommendations.
Regulatory compliance
The unit conforms to the following council Directives :
N°
Title
1999/5/CE
Radio and Telecommunications Terminal Equipment
Directive (R&TTE)
73/23/CE
Low voltage directive
2004/104/CE
EMC for motor vehicles
The device has been certified to comply with the European directives and is
appropriately CE marked.
N°
Title
EN61000-6-2
EMC emission, industrial grade
EN61000-6-4
EMC Immunity, industrial grade
EN301-489-17
EMC for radio equipment 2.4Ghz & 5GHz
EN300 328
Electromagnetic compatibility and Radio spectrum
Matters (ERM) ; Wideband transmission systems, 2.4
GHz ISM band
EN301 893
Broadband Radio Access Networks (BRAN) ;
5 GHz high performance WLAN
EN50155
EN50121-3-2
EN60068-2
EN61373
Railway, Electronic equipment used on rolling stock
(EMC, Climatical, Mechanical shocks & vibration)
MIL-STD-810F
Shocks & vibrations according to 514.5 and 516.5
methods
UTAC E2
CE standard for electronic equipments installed aboard
vehicle
The device also complies with Part 15 of the FCC rules (Common testing
standard for most electronic equipment).
