-
9
-
Wi-Fi Antenna connector
3 ports Ant.1, Ant.2 and Ant.3
N-type female screw connector
Signal name
Function
Ant.1
RF chain 1
Ant.2
RF chain 2
Ant. 3
RF chain 3
To get the full performance of the MIMO 3T/3R technology, you must
connect the 3 antennas (not provided).
Nevertheless, it possible to use, with degraded performances, the two
following configurations:
Ant.1
Ant.1 and Ant.2
In this case, it is recommended to put a 50 ohms terminator onto the
unused connectors.
Antenna configuration must be done as well in the product itself through
the internal webserver.
LEDs definition
The product has 8 LEDs to indicate the status of the product.
LED
Color
Description
Power 1
Green
This LED is ON when a power supply is connected
to pins PWR1 of the power connector or a POE
source is connected to LAN2
Power 2
Green
This LED is ON when a power supply is connected
to pins PWR2 of the power connector
Diag
Red/
Green
This led indicates the unit operational state.
OFF
:
Power supply is off
Red
:
Initialization during 60s after power is
applied then goes Green
Red for more 120s
:
hardware failure
Green
:
Ready to use
Blinking
:
Firmware in flash is loading
Device is in “emergency mode”
because firmware is corrupted. Re load
firmware with WaveManager
LAN 1
LAN 2
Green
/
Yellow
On:
Link on LAN established
Flashing
: Tx/Rx activity
Yellow
:
connected in 1000 BASE T
Green
:
connected in 100 BASE Tx
or 10 BASE T
Off
:
Link on LAN broken
C-KEY
Red/
Green
Off:
C-KEY in factory state
Red:
The C-KEY is not detected, data is
invalid or corrupt
Green:
The C-KEY data is valid
Blinking:
during reads and writes to the C-KEY
State
Green
Off:
the radio is disabled or DFS CAC
Blinking:
the product is unassociated
solid “
On
”
:
the product is associated
Activity
Blue
Flashing:
Radio Tx/Rx activity
Содержание RuggedAir1000
Страница 16: ...16 PAGE BLANCHE...
Страница 32: ...16 BLANK PAGE...
