Acksys RuggedAir1000, Быстрое руководство по установке

Страница: 18 / 32

-
2
-
HARDWARE INSTALLATION
1. Plug the antennas in
Plug the 3 antennas of your choice ( not included ) into the N-type
connectors.

For single antenna installation, use Ant.1 connector.

For dual antenna installation, use Ant.1 and Ant.2 connectors.
WARNING: It is recommended to connect a 50 ohms
terminator on unused antenna connectors. If not, it may
disturb radio link quality and data throughput, and as well as
waterproofness.
2. Connect the power supply
The device has 3 sources of power supply:

Power 1 through M12 PWR connector

Power 2 through M12 PWR connector

PoE through M12 LAN2 connector
See the “ specifications” section about the characteristics of the power
supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power

Power1 LED is ON if Power1 power supply or PoE source is ON.

Power2 LED is ON if Power2 power supply is ON.

The Diag LED stays red for around 60 seconds, until the device is
fully ready to use. Then the Diag LED turns green.
3. Connect the Ethernet cable

Plug the Ethernet cable to the device’s LAN1 or LAN2 M12
connector.

Check that the corresponding LAN LED turns ON at that point.

If the device is powered by a PoE source, use exclusively LAN2
connector