-
7
-
“ACKSYS WaveManager” doesn’t find your device
ACKSYS WaveManager only scans the local network. To reach a
device through a gateway, use the “search product” option and
enter an IP addresses range.
Check that your firewall does not block WaveManager.
How to restore factory settings
If the built-in web-based interface is reachable, you can use your
browser to restore factory settings.
Else, open the product, power up the unit, wait for the red “
Diag
”
LED to turn green, then hold down the reset button (for at least 2
seconds) until “
Diag
” goes red. Then release it and wait for the Diag
LED to turn green again, meaning that the product rebooted with its
factory settings. Close the product by tightening the screws to a
torque of 2Nm ± 10%.
RESET
Reset button is attainable by unscrewing the C-KEY (only the top screw). Use
exclusively a 2.5mm diameter plastic sharp object to press the button.
C-KEY REPLACEMENT
The C-KEY is a storage device used to save and restore the product
configuration. It should be removed and inserted only when the power supply
is OFF.
To remove the C- KEY, unscrew the 2 screws of the cover, and then gently
pull the device out. If needed, use the screwdriver as a lever, with the help of
the notches intended for this purpose at the base of the screw guides.
Tighten the C-KEY screw at 0.3Nm ± 10% to provide water tightness
