2
The charger requires minor assembly before it can be used. The distribution cable is packed
separately from the charger and must be connected to the terminals of the charger before use.
You will need a Philips head screwdriver for assembly. Follow these steps:
1. Identify the polarity of the terminals on the
cable as well as on the charger (see photos
on right).
†
2. Unscrew the terminal screws slightly and
insert the terminal forks
underneath
the
square washers.
3. Tighten the terminal screws with moderate
force. Do not overtighten.
4.
Put the plastic cap over the screw terminals to
prevent an accidental short. If the polarity is
reversed, the cap will not fit properly.
†
Do not connect charger with incorrect polarity to the dAck!, as this
will degrade and ultimately destroy the power cells.
Place the dAck! on a stable support surface in a secure location where it will not be
bumped into or knocked over. As with any high-fidelity equipment, a good support surface may
improve its performance by isolating it from external vibrations. Do not place any equipment or
small items on top of the dAck!’s vent holes. If you would like to prevent dust from entering the
chassis, it is OK to cover the unit with a light cloth when not in use.
Familiarize yourself with the dAck!’s inputs, outputs, and controls. The following
figures show the important features and their purposes.
Front
Back
