achilles KOOP A13S, Руководство пользователя

Страница: 15 / 28

14
moving on uneven ground or slopes.
When excavating on the slope, it is necessary to start from a high place to move
the machine to the downhill direction, and the bulldozer plate is at the rear and
pressed on the ground to discharge soil towards the uphill direction.
3
．
6
挖沟
The bulldozer plate is at the back and anchored into the soil.
Extend the boom and the stick and tilt the dipper teeth into the ground.
Start digging with the stick cylinder, and operate the bucket and the stick cylinder at
the same time during the half stroke of digging.
Note: do not insert the bucket too deep into the soil. If this happens, raise the
boom slightly, the bucket should also work smoothly. When the bucket is full, raise
the boom and the stick, keep the bucket level, and turn the platform to the dump
position for unloading.
8) Backfilling or leveling
In order to fill the trench, the excavator must be placed perpendicular to the direction
of the trench, and the bulldozer plate shall be pressed on the soil. Do not cut too deep.
After normal bulldozing, release the control lever.
8 . Transportation of excavator
The excavator drives itself up the slope of the transport vehicle.
In order to avoid any accident, it is recommended that the slope angle be less
than 15
°
, or the slope length be equal to 3.3 times of the height, and the slope width
be equal to 1.2-1.5 times of the track width (190mm).