ACF Greenhouses Cross Country Series, Инструкция по эксплуатации

Страница: 28 / 39

C R O S S C O U N T R Y S E R I E S S T R A I G H T M O D E L • G R E E N H O U S E I N S T R U C T I O N S
16. VENT ASSEMBLY
(SEE DRAWING & PICTURES PAGES 29 & 30)
1. Lay down the gutter with the punches facing up towards you.
2. Polybars with sliders on are for the end. Lay them down with the bolt slot facing up.
3. Hinge with punches facing up towards you.
4. Slide the bolts into both ends of the end bar. Take the gutter and line up the bolt with the 1st
punch, slide the bolt down and tighten it. Do the same with the hinge, other side and center
bar. Make sure that the polybars are tightly fitted to the gutter and hinge after vent assembled.
5. Turn it over and put a square where the polycarbonae goes. Shift to square.
6. Put 1/8” foam on the polybars.
7. Take polycarbonate panel, remove the film (clear inside) and slide it into the hinge track.
Before you do this; remove the paper and lightly spray the foam so that it doesn’t stick. Lay it
on the foam and slide it into the hinge (top) section and then down into the gutter track. Do
the same with the next piece.
8. Take the caps and lay them on the bars, center them, fasten with 1/2" screws.
9. Take the silicone gun and seal where the sheets slide into the track. Inside and out.
17. VENT INSTALLATION
Take the vent and slide it in the end of the ridge. You will have to remove a the screw in the
ridge. Then push it into place
and put the screw back in. Now
attach manual opener
(picture A).
A
– 27 –
ACF Greenhouses