![background image](http://html.mh-extra.com/html/acer/acerpower-8600/acerpower-8600_user-manual_5736035.webp)
23
Correcting Error Conditions
As a general rule, the "Press F1 to continue" error message is caused
by a configuration problem which can be easily corrected. An
equipment malfunction is more likely to cause a fatal error, i.e., an
error that causes complete system failure.
Here are some corrective measures for error conditions:
1.
Run Setup. You must know the correct configuration values for
your system before you enter Setup, which is why you should
write these values down when the system is correctly configured.
An incorrect Setup configuration is a major cause of power-on
error messages, especially for a new system.
2.
Remove the system cover according to the directions in the
system housing installation guide. Check that the system board
and any expansion boards are set correctly.
3.
Check that all connectors and boards are secure. Consult the
system housing installation guide for assistance.
PS/2 Keyboard Interface Error
Contact your dealer or an authorized
service center.
PS/2 Pointing Device Error
Reconnect or replace the pointing
device.
PS/2 Pointing Device
Interface Error
Contact your dealer or an authorized
service center.
PS/2 Keyboard Locked
Unlock the keyboard.
RAM Parity Error
Replace the RIMM chips or disable
parity check in Setup if the model
supprots it.
Real-time Clock error
Contact your dealer or an authorized
service center.
System Management Memory
Bad
Replace the RIMM chips.
Error Message
Corrective Action
Содержание AcerPower 8600
