E - 3
English
INSTALL THE
MONITOR
• To connect the tilt/swivel base to the monitor, align
hooks with the sockets on bottom side of the
monitor, and gently push the base towards the front
of the monitor.
• The 15-pin D-shell signal connector on the signal
cable will connect easily to the video adapter
output on your personal computer. Lock both
screws on the connector to ensure a firm
connection.
• Turn the PC power switch ON. Then turn the
monitor power switch ON, by pressing the switch
inward. The green power indicator will light up.
• Allow about 30 seconds for the CRT tube to warm
up. Data will be displayed on the screen.
• If your display fails to function properly, please
first refer to the section "Troubleshooting" in this
manual.
POWER CORD
•
Check first to make sure that the power cord you
use is the correct type required for your area.
•
Type NO: C1996NSL
This monitor has a universal power supply that
allows operation in either 100/120V AC or 200/
240V AC voltage area. No user-adjustment is re-
quired.
• First connect the power cord into your monitor’s
power input socket, and then plug the other end
into a 3-pin AC outlet. The power cord may be
connected to either a wall socket or the power out-
put socket on your PC, depending on the type of
power cord supplied with your monitor.
• For units to be used at 120V AC:
Use a UL Listed Cord Set consisting of a min.
No. 18 AWG, Type SVT or SJT three-conductor
a maximum of 10 ft. in length and a parallel blade,
grounding type attachment plug rated 10A, 125V.
• For units to be used at 240V AC (domestic use):
Use a UL Listed Cord Set consisting of a min. No.
18 AWG, Type SVT or SJT three-conductor cord
a maximum of 10 ft. in length and a tandem blade,
grounding type attachment plug rated 10A, 250V.
• Type NO: C1996PNST
For units to be used at 220/240V AC (outside of
U.S.):
Use a Cord Set consisting of a min. 0.75mm
2
,3G,
Type H05VV-F cord and grounding type attach-
ment plug rated 16A, 250V. The cord set should
have the appropriate safety approvals for the coun-
try in which the equipment will be installed and
marked HAR.
