eBoard Installation guide
19
For the 1
st
HW installation, you have to execute
“Initial Setup” to mesure the distance
between 2 receivers. Also, if you changed the receiver position, you need this step again.
However, if you execute calibration again for other purpose after initial
t
installation, click
Screen Calibation. You don
’t need “Initial setup” any more.
7.2.1 Initial Set up
If it is not the 1
st
HW installation or did not change receiver position, skip this step and go to
3.2.2 Screen Calibration.
In order for calculating (x,y) coordinates of pen position, eBoard should know constant
distance between two receivers
. That’s why we need initial setup only for the 1st installation
or changed sensor position.
However, i
t doesn’t cause problems for repetitive execution.
[Step 1] click [Initial setup], then the pop-up window will be displayed as follows.
.
If you are in the 1
st
HW installation or not changed receiver position, click [YES].
If not so, click [NO].
