31
Before removing
¿
rst tighten the two screws gently, counting the number of turns
R
emove screws. Do not use excessive force to avoid damaging the air adjusting screw
head surface.
• Remove the main fuel injection nozzle and fuel injection needle seat.
FLOAT CHAMBER INSTALLATION
,QVSHFWWKHÀRDWIRUDQ\GDPDJHDQGIRUIXHOLQWKHÀRDW,QVSHFWWKHÀRDWYDOYHDQGÀ
oat valve
seat for wear. If there is wear, it should be replaced.
Clear every fuel line and air line on the carburetor body with compressed air.
FLOAT CHAMBER INSTALLATION
• Install the main fuel injection nozzle and fuel injection needle seat.
• Install the air adjusting screw and choke adjusting screw, and turn them to the proper position ac-
cording to the noted number of turns while removing.
0RXQWWKHÀRDWYDOYHWKHÀRDWDQGWKHÀRDWSLQ
• T
LJKWHQWKHÀRDWSLQSRVLWLRQLQJVFUH
w.
FUEL LEVEL INSPECTION
• Measure the fuel level height.
Fuel level height
18.5mm
,QVSHFWWKHÀRDWIRUDQ\GDPDJHDQGLQVSHFWWKHÀ
oat valve for excess wear.
&RQ¿UPWKDWWKHXSDQGGRZQPRYHPHQWRIWKHÀ
oat is normal.
CARBURETOR INSTALLATION
,QVSHFWWKHÀRDWIRUDQ\GDPDJHDQGLQVSHFWWKHÀ
oat valve for excess wear.
&RQ¿UPWKDWWKHXSDQGGRZQPRYHPHQWRIWKHÀ
oat is normal.
CARBURETOR INSTALLATION
• Reverse the removal procedure for installation.
• After installing, confirm that all carburetor linkage and cables are in correct position. Verify that
carburetor is in idle position.
Содержание Maxxam 150 2R
