7
Step 8:
Adjust the step so that it is horizontal under the vehicle (Fig. 15
–
17).
Figure 17
Figure 16
Figure 15
Parallel to
ground
Step 9:
adjust the step in
the inward position
forwards or backwards so
that it sticks out as far as
possible
not
exceeding 1
cm outward
of the
footprint of the vehicle.
Step 11:
Electrically open the step and
check if both swing arms lock in final
position. If one swing arm shows a gap
you need to adjust the height at the rear.
Step 12:
Tighten all
bolts and nuts to
complete the installation
of the step.
M8 = 24 Nm M6 = 10
Step 10:
Electrically install
the step (See
section 7.2)
