10
The distance between the end of the switch and the door should still be 8.5 mm.
IMPORTANT:
Max torque to fit the switch is 5 Nm (This is light hand tight)
If you use higher torque, the
switch will break / crack, which will lead to unreliable door signals.
9.
Place the red LED in the dashboard in the direct view of the driver. Connect the red wire coming
from the LED to the 12 V power. The LED should light up red when the step is in outward and
flashes when the step is moving in or out.
10.
Connect the black wire to ground. Connect the red wire to 12V
power.
You have to add a fuse of 20 Amp
between the battery
and the power cable. Decide whether to connect the step to
constant power or to power behind the main switch. We
recommend placing the step behind the main switch. The step
ECU has a sleep mode using less than 1 mAmp in standby
mode.
11.
If you decide to use driver operation, place a switch on the dashboard
and connect it to the Green wire. Closed signal => step out. Open
signal => step stowed. To prevent oversight from the driver’s point, also
install the door switch to prevent driving with the step in outward
position.
Connect the cable loom to the step
with the connectors.
