- 12 -
3. Safety reverse force adjustment
4. Auto-close setting
5
．
Photo beam setting
6. O/S/C Terminal
Press „SET‟ button and hold on until the LED displays
„3‟. It‟s under force adjustment mode. LED shows the
current force level.
Press „UP‟ button to increase the force level and
„DOWN‟ button to decrease the force level.
Version 1: Maximum force level is 9, minimum is 1.
Please make sure the photo beam is connected and can
work properly before you choose level 4~9.
Version 2:
Maximum force level is 3, minimum is 1.
Press „SET‟ button to confirm.
Press „UP‟ button and hold on, the LED will display the
current setting (the factory default setting is
„0‟).
Press „up‟ button once, the auto-close time will increase 1
level, the maximum is level
9. Press „down‟ button once,
the auto-close time will decrease 1 level.
The auto-close function will be turned off when LED
displays 0.
Version 1: 1 level = 60seconds
Version 2: 1 level = 15seconds
Press „SET‟ button to confirm. When the auto-close
function is activated, the full opened door will auto-close
after the set time.
Press „DOWN‟ button and hold on until the LED displays
„||‟.
P
ress „UP‟ button the LED displays „H‟, photo beam
function is available.
Press „DOWN‟ button the LED displays „||‟ to cancel this
function.
P
ress „SET‟ to confirm.
Make sure that the connected infrared sensor is controlled
by switching value, and wiring as Fig. 15
Notice:
If photo beam function is activated, while the
photo beam is not connected, the door will not close.
Connecting a touch off switch to this terminal (Fig. 16),
you can use the switch inside the garage to control the
open/stop/close of the door when maintaining or the
transmitter is lost.
Содержание RAPTOR
Страница 16: ...14 Wiring guide Fig 15 Fig 16 Fig 17 Fig 19 Fig 18...
Страница 20: ...18 1 0 0 220105...
